33 55 000 Removing and installing/replacing rear anti-roll bar

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Undo ANTI-ROLL BAR LINKS AT THE ANTI-ROLL BAR .
Lower REAR AXLE SUPPORT .

Release screw (1). (Left side only.)

Tightening torque 33 32 6AZ.

Installation note:

Replace screw.

TIGHTEN DOWN SCREW CONNECTION IN NORMAL POSITION .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: To simplify the illustration, anti-roll bar removal is shown on the removed rear axle.

Release screws (1).

Tightening torque 33 55 1AZ .

Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .

Turn anti-roll bar (2) and remove toward the left side.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check both rubber mounts for damage and replace if necessary.