33 55 021 Replacing both rubber mounts for anti-roll bar mounting
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Lower REAR AXLE SUPPORT .
Release screws (1).
Tightening torque, 33 55 1AZ .
Remove retaining brackets (2).
Slide rubber mount (3) towards vehicle exterior and remove.
Installation note:
Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.
Clean anti-roll bar on both sides.
Slide rubber mount with retaining bracket on anti-roll bar to installation position.