33 32 031 Replacing rubber mount for trailing arm in wheel carrier

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 3 010
2 240 471
2 240 466
2 240 472

The rubber mount may not be reused after it has been pressed out!

Necessary preliminary tasks:

Remove TRAILING ARM .

Pulling out the rubber mount:

Pull out rubber mount with special tools 33 3 010, 2 240 471, and 2 240 466.

NOTE: Align the slots on tool 2 240 471 with the wheel carrier so that it is resting straight.

Courtesy of BMW OF NORTH AMERICA, INC.

Pulling in a new rubber mount:

Align the rubber mount with slot (1) upward in an angle to the wheel carrier.

Courtesy of BMW OF NORTH AMERICA, INC.

Pull on rubber mount (1) with special tools 33 3 010, 2 240 471, and 2 240 472 until limit position.

NOTE: Align the slots on tool 2 240 471 with the wheel carrier so that it is resting straight.

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Carry out WHEEL ALIGNMENT .