31 12 050 Removing and installing/replacing left or right trailing link

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Refer to REMOVING FRONT WHEEL

Release screws (1).

Remove cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1), if necessary, grip at inner Torx socket.

Tightening torque 31 12 2AZ .

Installation note:

Replace self-locking nut.

Keep trailing link to swivel bearing connection clean and free from oil and grease.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 31 12 1AZ .

Remove tension strut.

Installation note:

Replace screw (1).

Tighten down SCREW CONNECTION in normal position.

Courtesy of BMW OF NORTH AMERICA, INC.