33 55 000 Removing and installing/replacing rear anti-roll bar
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Undo the ANTI-ROLL BAR LINKS AT THE ANTI-ROLL BAR .
- Lower the REAR AXLE SUPPORT .
Release screw (1). (Left side only.)
Tightening torque, refer to: 33 32 6AZ .
Installation note:
Replace screw.
Tighten down screw connection in NORMAL POSITION .
NOTE:
To simplify the graphic, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Tightening torque, refer to: 33 55 1AZ .
Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .
Turn anti-roll bar (2) and remove toward the left side.
Installation note:
Check both rubber mounts for damage and replace if necessary.