33 52 010 Removing and installing rear left or right shock absorber

When supporting components, make sure that:

• the vehicle can no longer be raised or lowered.
• the vehicle does not lift off the locating plates on the vehicle hoist.

Attention! 

• Read and comply with INFORMATION ON REPLACING SHOCK ABSORBERS. 

Installation note: 

1. All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
2. Retaining elements on chassis and suspension and steering parts must be replaced.

Necessary preliminary work: 

• Remove the REAR WHEEL.
• Remove the CAMBER ARM COVER .

Support wheel carrier with workshop jack.

Slacken nut (1).

Tightening torque, refer to: 33 52 3AZ

Lift wheel carrier with workshop jack to the point where the screw can be removed.

Slowly lower workshop jack until wheel carrier is suspended.

Remove workshop jack from under vehicle.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Replace screw and nut.

Note direction of insertion of screw.

Tighten down screw connection in NORMAL POSITION .

Release screws (1) on support bearing.

Tightening torque, refer to: 33 52 1AZ .

Installation note: 

Replace screws.

Courtesy of BMW OF NORTH AMERICA, INC.

Press shock absorber together and remove upward from wheel arch.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Check protective cap (1) and sealing washer (2) for damage and replace if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.