33 17 005 Replacing the rubber mounts for the rear axle final drive suspension at rear

Special tools required: 

• 33 0 163
• 33 0 031
• 33 0 032
• 33 0 035
• 33 0 036
• 33 5 105

  Courtesy of BMW OF NORTH AMERICA, INC.

• 33 4 465
• 33 4 466
• 33 3 233
• 33 5 166
• 33 5 200

Do not press the rubber mount in and out more than once.

Necessary preliminary tasks: 

• Remove the REAR AXLE FINAL DRIVE .
• Lower the REAR AXLE SUPPORT .

Attention! 

Determine the installation position of the rubber mount before pressing it out to ensure a correct installation of the rear axle differential.

For this purpose, attach special tool 33 0 163 from the front. Measure the protrusion (A) and notate.

Courtesy of BMW OF NORTH AMERICA, INC.

Withdrawing rubber mount: 

Pull out rubber mount with special tools 33 0 031, 33 0 032, 33 0 035 and 33 0 036.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing rubber mount: 

Attention! 

Align rubber mount horizontally by way of elongated hole (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in the rubber mounts using special tools 33 4 465, 33 4 466, 33 3 233, 33 0 163 and 33 5 166 to the protrusion (A) determined prior to removal.

Courtesy of BMW OF NORTH AMERICA, INC.

Assembly sequence: 

1. Insert the rear axle differential into the rear axle support using the workshop jack and special tool 33 5 200.
2. Insert screws (1) (do not tighten).
3. Insert bolt from rear and replace nut (2) (do not tighten down).
4. Release tensioning strap and lower special tool 33 5 200 and move away.
5. Tighten down screws (1).

   Tightening torque, refer to: 33 17 1AZ .

6. Tighten nut (2).

   Tightening torque, refer to: 33 17 2AZ .

Courtesy of BMW OF NORTH AMERICA, INC.