13 62 538 Removing and installing/replacing temperature sensor for charge air (B48)

WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove the DESIGN COVER .

Removal:

Unlock and disconnect plugs (1).

Loosen temperature sensor for charge air (2).

Guide out temperature sensor for charge air (2) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation for installation:

Replace sealing rings (1) if damaged.

Part: Sealing ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guide in temperature sensor for charge air (2) and install.

Tighten temperature sensor for charge air (2).

Tightening torque, refer to: 13 62 4AZ .

Attach and lock connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install the DESIGN COVER .