Removing and installing/replacing rear anti-roll bar
WARNING:
High-voltage system - danger to life
- Observe SAFETY INFORMATION for handling electric vehicles.
Necessary preliminary tasks:
- Undo ANTI-ROLL BAR LINKS AT THE ANTI-ROLL BAR .
- Lower REAR AXLE SUPPORT .
Release screw (1). (Left side only.)
Tightening torque 33 32 6AZ .
Installation note:
Replace screw.
Tighten down screw connection in NORMAL POSITION .
NOTE:
To simplify the graphic, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Tightening torque 33 55 1AZ .
Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .
Turn anti-roll bar (2) and remove toward the left side.
Installation note:
Check both rubber mounts for damage and replace if necessary.