Replacing both anti-roll bar rubber mounts
WARNING:
High-voltage system - danger to life
- Observe SAFETY INFORMATION for working with electric vehicles.
Necessary preliminary tasks:
- Lower REAR AXLE SUPPORT .
Release screws (1).
Tightening torque, 33 55 1AZ .
Remove retaining brackets (2).
Slide rubber mount (3) towards vehicle exterior and remove.
Installation note:
Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.
Clean anti-roll bar on both sides.
Slide rubber mount with retaining bracket on anti-roll bar to installation position.