Installing the high-pressure line between the high-pressure pump and the high-pressure rail
- Guide the special tool 2 413 106
out and remove.
- Thread in and install the high pressure line (2).
- Tighten union nut (1) hand tight.
- Tighten union nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| High pressure line between high pressure pump and rail | ||
|---|---|---|
| M14 | Tightening torque | 33 Nm |
Follow-up work
- Refer to INSTALLING THE IGNITION COILS .
- Refer to INSTALLING CORROSION PROTECTION COVER .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
- Refer to REMOVING/INSTALLING TRAILING LINK AT TENSION STRUT TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .