Installing fuel delivery line
- Guide the fuel delivery line (3) in and install.
- Install rubber damper (2).
- Check the rubber damper (2) for the correct fit.
- Tighten the union nut (1) hand-tight.
- Tighten union nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Fuel delivery line to high pressure pump | ||
|---|---|---|
| M14 | Tightening torque | 26 Nm |
- Slide in and lock the fuel supply line in the direction of the arrow in the snap fastener (2).
The fuel supply line must be audibly engage in the snap fastener (2).
- Secure the clamp (1).
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Fuel delivery line to cylinder head cover | ||
|---|---|---|
| M6 screw | tightening torque | 7 Nm |
Follow-up work
- Refer to INSTALLING THE IGNITION COILS .
- Refer to INSTALLING CORROSION PROTECTION COVER .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
- Refer to REMOVING/INSTALLING TRAILING LINK AT TENSION STRUT TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .