Installing both actuators

NOTE: The figure shows the rear of the engine.

Position both actuators.
Connect and lock both connectors (1).
Make sure the connectors (1) engage audibly.

G12728904

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.

Position special tool 2 360 895 correctly on the actuator (1) of the exhaust side.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the actuator (1) of the exhaust side and turn it in the direction of arrow with the special tool 2 360 895 until the limit stops touch the clamps.

G12701202

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.

Position special tool 2 360 895 correctly on the actuator (1) of the intake side.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the actuator (1) of the intake side and turn it in the direction of arrow with the special tool 2 360 895 until the limit stops touch the clamps.

G12701203

Courtesy of BMW OF NORTH AMERICA, INC.

Position the attachment part (2).

TIGHTENING TORQUE SPECIFICATIONS

Sealing frame attachment part
M6x20	2.3 Nm

Tighten the screws (1).

G10098374

Courtesy of BMW OF NORTH AMERICA, INC.

Position the engine bulkhead (2).
Tighten nuts (1).

TIGHTENING TORQUE SPECIFICATIONS

Engine bulkhead to bulkhead
Sheet metal nut	2.6 Nm

G12701195

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Engine compartment bulkhead, bottom to body
M8x18	19 Nm

G12701194

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING CORROSION PROTECTION COVER .
Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
Refer to REMOVING/INSTALLING TRAILING LINK AT TENSION STRUT TOWER
Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .