Installing the oil-level sensor
Prepare the oil-level sensor
- Replace sealing ring (1).
Parts: Sealing ring
- Install the oil-level sensor (3).
- Tighten nuts (2).
TIGHTENING TORQUE SPECIFICATIONS
| Oil-level sensor to oil sump | ||
|---|---|---|
| M6 | Joining torque | 2.5 Nm |
| Tightening torque | 8.5 Nm | |
- Connect and lock the connector (1).
The connector (1) must engage audibly.
- Top up the motor oil.
- Check the oil-level sensor (3) for tightness.
Follow-up work
- Refer to TOPPING UP THE MOTOR OIL .
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .