17 51 001 Remove and install/replace the right charge air cooler (N63) (X6 xDrive 50i)

WARNING: Risk of scalding!
Only perform this repair work after engine has cooled down!

Necessary preliminary tasks:

Remove CHARGE AIR HOSE on right.
Remove front underbody protection.
Remove FAN COWL .
FOLLOW instructions for repair work on the cooling system.

IMPORTANT: When loosening the coolant hoses from the charge air cooler, make sure that the connector remains connected to the throttle body. Coolant may not penetrate the plug connection at the throttle body.

Disconnect coolant hoses from charge air cooler using PINCH-OFF TOOLS (to prevent coolant from escaping).

Catch and dispose of escaping coolant.

Release and disconnect coolant hoses (1).

Detach coolant hose (2) from charge air cooler.

Replace faulty hose clamps.

Loosen the tank vent valve on the side of the charge air cooler.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screw (2).

Tightening torque 13 71 6AZ .

Installation note:

Screw (2) is longer than screws (3)

Release screws (3).

Tightening torque 13 71 6AZ .

Release clamp (4) on throttle valve unit.

Tightening torque 13 71 7AZ .

Lift out charge air cooler.

Replace faulty hose clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.

After having completed repair work, coolant level for charge air cooler and top up if necessary.