17 11 035 Removing and installing/replacing the fan cowl with electric fan (N63) (X6 xDrive 50i)
Necessary preliminary work:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove INTAKE SILENCER HOUSING .
Unclip Bowden cable for engine compartment lid operation from transverse reinforcement.
Release screws (1). Replace screws.
Tightening torque 17 10 4AZ .
Remove transverse reinforcement (2).
Release coolant hose (1) from fan cowl.
Unlock connector (1) and remove.
Press lock (1).
Raise fan cowl (2) until holder (3) can be folded into center of vehicle.
NOTE:
For reasons of clarity, graphic and text show coolant hose removed.
Do not raise fan cowl by fan wheel.
Do not raise fan cowl by fan wheel.
Press lock (1).
Feed out fan cowl (2) towards top and remove.
Installation note:
Insert retaining tab (1) at bottom on module carrier.
NOTE:
Check stored fault message.
Reassemble the vehicle.
Clear diagnostic fault entries from fault memory.
Reassemble the vehicle.
Clear diagnostic fault entries from fault memory.