66 53 120 Removing and installing/replacing front camera (X6 2015-2019)

Special tools required:

Necessary preliminary tasks:

Version A:

Attention!

Risk of damage!

Diaphragm (1) must not come into contact with latch mechanism (2) during removal and installation.

Diaphragm (1) must not come into contact with grease (e.g. contact with skin).

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, unlock and disconnect plug connection for front camera.

Insert special tool 00 9 340 between front camera (1) and latch mechanism thus protecting diaphragm.

Unlock latch mechanisms and remove front camera (1).

Installation note:

Protect diaphragm with special tool 00 9 340.

Make sure latch mechanisms are correctly fitted.

Courtesy of BMW OF NORTH AMERICA, INC.

Version B:

Attention!

Risk of damage!

Diaphragm (2) must not come into contact with latch mechanism of the front camera during removal and installation.

Diaphragm must not come into contact with grease (e.g. contact with skin.)

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect the connector (1).

Unlock latches at marked points.

Remove front camera (2).

Installation note:

Make sure latch mechanisms are correctly fitted.

Replacement:

Carry out the service function: