66 20 516 Removing and installing/replacing a front right ultrasonic sensor (X6 2015-2019)
Necessary preliminary tasks:
- Partially detach FRONT WHEEL ARCH COVER
(right)
On version with auxiliary radiator:
- Remove front BUMPER PANEL .
Unfasten plug connection (1) and disconnect.
Unlock catches (2) and remove ultrasonic transducer from holder.
Installation note:
Before installation of ultrasonic sensor on wiring harness, clean plug connection!
Make sure electrical lead (4) is correctly guided in cable fastener (3).
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).