Removing and installing/replacing heat shield at top (S63T2) (X6 M)
IMPORTANT:
Do not carry out test drives without heat shield (risk of fire!)
.
Necessary preliminary tasks:
- Remove ENGINE COVER .
- Remove PARTITION WALL from the engine compartment.
- Remove RIGHT CONTROL SENSOR and LEFT CONTROL SENSOR .
Graphic N63
Release retaining clip (1).
Detach wire ring (2) and set down behind oxygen sensor.
Release bolts (1) through 180°.
Tightening torque 11 65 3AZ .
Release bolts (1) through 180°.
Tightening torque 11 65 3AZ .
Lift out heat shield.
Installation note:
Clip in heat shield (1) into retaining clip, see arrow.
Assemble engine.