Removing and installing/replacing engine bulkhead (X6 M)
Necessary preliminary tasks:
- Remove LEFT MICROFILTER HOUSING COVER .
- Remove MICROFILTER HOUSING (UPPER SECTION) .
Engine bulkhead center:
Remove gasket (1) for engine compartment lid.
Release screws (2, 3).
Remove partition wall (4).
Installation note:
Make sure partition wall is correctly positioned.
Engine bulkhead left:
Release expanding rivet (1).
Unfasten screws (2).
Unfasten cable clip (3).
Remove partition wall (4).
Installation note:
Replace damaged and missing expanding rivets.
Make sure partition wall is correctly positioned.
Make sure screws are installed in correct positions.
Engine bulkhead right:
Release expanding rivet (3).
Release screws (1, 2).
Remove partition wall (4).
Installation note:
Replace damage or missing expanding rivet (1).
Make sure partition wall is correctly positioned.
Make sure screws are installed in correct positions.