Replacing left control sensor (S63T2) (X6 M)

Special tools required:

11 7 020

WARNING: Risk of burning! Only perform this work after engine has cooled down.

Necessary preliminary tasks:

Check function of DME.
Switch off ignition.
Remove BRACKET .

Unclip control sensor cable (2) at retaining clips (3).

Unlock plug connection and detach.

Courtesy of BMW OF NORTH AMERICA, INC.

Release control sensor with special tool 11 7 020.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The threads of new oxygen control/monitoring sensors are already coated with 4.2 NEVER SEEZ COMPOUND (refer to the applicable BMW Parts Catalogue).

If a lambda control/monitoring sensor is to be reused, apply a thin and even coating of Never Seez Compound to the thread only.

The part of the lambda control/monitoring sensor which projects into the exhaust branch (sensor ceramics) must not be cleaned and not coated with lubricant.

Secure control sensor with special tool 11 7 020 and a torque wrench.

Tightening torque 11 78 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check function of DME control unit.

Pay attention to cable routing of control sensor.