Removing and installing/replacing drive unit for tailgate lock (X5 M)

Necessary preliminary tasks: 

• Remove TRIM FOR REAR LID LOWER SECTION .

Lift off cover (1), slacken screw and remove handle (2).

Tightening torque 51 24 6AZ .

Lever out cover (3) and release screw underneath.

Tightening torque 51 49 9AZ .

Installation note: 

Replace faulty covers (1 and 2).

Courtesy of BMW OF NORTH AMERICA, INC.

Detach Bowden cable (1 and 2).

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1) and carefully remove drive (2).

Tightening torque 51 24 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.