Removing and refitting/replacing trim panel for boot lid lower section (X5 M)

Lift trim (1) slightly and unhook springs (2).

Release screws (3).

Tightening torque 51 49 1AZ .

IMPORTANT: Risk of damage!
Boot lid must not be closed whiles springs (2) are unhooked.

Courtesy of BMW OF NORTH AMERICA, INC.

Starting at the side, pull trim panel (1) upwards and in so doing detach it from the clips (2).

If necessary, disengage cable for emergency release mechanism.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1) and guides (2) must not be damaged.

Make sure catches (1) and guides (2) are correctly seated.

Courtesy of BMW OF NORTH AMERICA, INC.