31 51 020 Replacing radial shaft seal for output shaft, right

Special tools required:

31 5 130

Necessary preliminary work:

Remove RIGHT OUTPUT SHAFT .

Lever radial shaft seal (1) with a screwdriver (2) out of bearing block (3).

Fig 1: Removing Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Protective sleeve (1) serves to protect the sealing lips of radial shaft seal (2) from being damaged when the output shaft is inserted into the bearing block.

Fig 2: Identifying Protective Sleeve And Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Drive in radial shaft seal with special tool 31 5 130 as far as it will go.

Fig 3: Identifying Special Tool 31 5 130

Courtesy of BMW OF NORTH AMERICA, INC.