51 24 110 Removing and installing/replacing lock for rear lid upper section

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove PANEL FOR REAR LID

Release screw (1).

Feed out Bowden cable (2) and remove cover (3).

Fig 1: Identifying Cover, Bowden Cable, And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 24 1AZ .

Feed out lock (2), disconnect plug connection and remove lock (2).

Fig 2: Identifying Lock And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unhook Bowden cable (1) from lock (2).

Fig 3: Identifying Bowden Cable And Lock

Courtesy of BMW OF NORTH AMERICA, INC.