61 31 342 Removing and installing/renewing gear selector switch

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Clamp off BATTERY NEGATIVE LEAD
Remove CENTER CONSOLE TRIM

Release screws (1). Tightening torque 51 16 2AZ .

Raise gear selector switch carrier (2) and disconnect all plug connections.

Remove gear selector switch carrier (2).

Fig 1: Identifying Gear Selector Switch Carrier And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove TRIM FOR GEAR SELECTOR SWITCH .

Release screws (1). Tightening torque 61 31 4AZ .

Remove gear selector switch (2) from gear selector switch carrier (3).

Fig 2: Identifying Gear Selector Switch, Carrier, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/ENCODING .