13 54 030 Removing and installing/sealing throttle body (N55)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary work:

Switch off ignition.
Remove rear CHARGE-AIR DUCT .

Unlock connector (1) and remove.

Unlock and disconnect hoses (2) and (3).

Remove tank vent valve (4) from holder in the direction of arrow and place aside.

Fig 1: Removing Tank Vent Valve From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screws (3).

Partially remove throttle body (4) and unlock tank ventilation line (2) and remove.

Tightening torque: 13 54 1AZ .

Remove throttle body (4).

Fig 2: Identifying Throttle Body And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing ring (1) of throttle body (2).

Fig 3: Identifying Sealing Ring Of Throttle Body

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check stored fault message.

Delete fault memory.