13 71 000 Removing and installing/replacing intake silencer housing (N55)

WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove intake port. See 13..... REMOVING INTAKE PORT (N55) .

Detach line clip (1) from intake silencer housing in upward direction.

NOTE: For clarification purposes, the drawing does not show upper part of intake silencer housing installed.

Fig 1: Detaching Line Clip From Intake Silencer Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamp (1).

Tightening torque: 13 71 3AZ .

Pull intake silencer housing (2) off rubber mounts in an upward direction and remove.

Fig 2: Pulling Intake Silencer Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.