61 31 221 Removing and installing/replacing both multifunction steering wheel switches
Necessary preliminary work:
- Remove AIRBAG UNIT
- If necessary, remove the SHIFT PADDLES
Disassembly of the steering wheel is not necessary!
Removal:
Release screws (1) on left/right on back of steering wheel (2).
Pull off the switch of the multifunction steering wheel (1) to the left and feed out cable (2).
Unclip the switch of the multifunction steering wheel (2) on the right and disconnect the connector (1).
Installation:
Connect the connector (1) to the switch of the multifunction steering wheel (2) on the right.
Clip in the switch of the multifunction steering wheel (2) on the right into the steering wheel.
Installation note:
Make sure multifunction steering wheel switch (2) is fitted correctly.
Make sure electrical wiring is correctly routed.
Clip in the switch of the multifunction steering wheel (1) on the left.
Feed in cable (2).
Installation note:
Make sure multifunction steering wheel switch (1) is fitted correctly.
Make sure electrical wiring is correctly routed.
Tighten the screws (1) on left/right on back of steering wheel (2).
Tightening torque 61 31 7AZ .
Required reworking:
- Install SHIFT PADDLES if needed
- Install AIRBAG UNIT