LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2017 >> X1 sDrive28i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Maintenance And General Information - Repair (F48 AWD)) >> 00 11 General Maintenance >> 00 11... Checking/topping up oil level in rear axle final drive

00 11... Checking/topping up oil level in rear axle final drive

WARNING: This page is about a different variant/trim than selected.

Attention! 

NOTE: Risk of damage! 
To avoid serious damage to the rear axle final drive, it is essential to use only approved gearbox oils in the rear axle final drive. Refer to: REAR AXLE - OPERATING FLUIDS
G12884396Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1).

Remove cover (2).

Open screw plug (1).

Check oil level.

G12884397Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, pour in final drive oil up to lower edge of opening for screw plug (1).

Replace screw plug (1) with O-ring.

Parts:  Plug

Apply screw plug (1).

Tightening torque, refer to: 33 11 1AZ .

G12884396Courtesy of BMW OF NORTH AMERICA, INC.

Position cover (2).

Tighten down screws (1).

Tightening torque, refer to: 33 31 8AZ .