33 31 Rear axle support
WARNING: This page is about a different variant/trim than selected.
33 31 REAR AXLE SUPPORT - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Rear axle carrier to body | F39/F45/F46/F48/F49/F52 | M12 | Replace screws. | 100 Nm |
| 2AZ Cross member/bridge to rear axle support | F39/F45/F46/F48/F49/F52 | M12 | Replace screws. Tightening torque Angle of rotation |
100 Nm 90° |
| 3AZ Cross member to body | F39AWD/F45AWD/F46AWD/F48AWD/F49AWD | M12 | 100 Nm | |
| 4AZ Cross member to rear axle final drive | F39AWD/F45AWD/F46AWD/F48AWD/F49AWD | M10 | 56 Nm | |
| 5AZ Hydraulic vibration absorber to cross member | F39AWD/F45AWD/F46AWD/F48AWD/F49AWD | M12 | Replace screw. | 96 Nm |
| 6AZ Vibration absorber to cross member | F39AWD/F45AWD/F46AWD/F48AWD/F49AWD | M8 | Replace screw. | 28 Nm |
| 7AZ Additional mass to cross member | F39AWD/F45AWD/F46AWD/F48AWD/F49AWD | M8 | Replace screw. | 28 Nm |
| 8AZ Cover to cross member/rear axle differential | F39AWD/F45AWD/F46AWD/F48AWD/F49AWD | M6 | 12 Nm | |
| 9AZ Vibration absorber on side member/body on the rear left and right | F39 | 50 Nm |