13 62 591 Replacing the charge air pressure sensor (on intake plenum) (B38, B46, B48)
WARNING: This page is about a different variant/trim than selected.
Removal:
Unlock connector (1) and pull off.
Remove charging pressure sensor (2). Unclip and remove.
Preparation for installation:
Check sealing ring of charge-air pressure sensor and replace if damaged.
Part: Sealing ring
Prior to installation, apply a thin coat of anti-friction agent to sealing ring of charge-air pressure sensor.
Installation:
Install charging pressure sensor (2).
Attach connector (1).
Connector (1) must engage audibly.