12 14 523 Replacing pulse sensor on intake camshaft (B46, B48)
WARNING: This page is about a different variant/trim than selected.
Attention!
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) !
Necessary preliminary work:
- Remove ACOUSTIC COVER
Removal:
Unlock connector (1) and pull off.
Release screw (2).
Remove pulse generator (3).
Installation:
Check gasket, replace damaged gasket.
Part: Gasket
Install pulse sensor (3).
Tighten screw (2).
Tightening torque 13 62 1AZ .
Attach connector (1) on pulse sensor.
Connector (1) must engage audibly.
Required follow-up work
- Install ACOUSTIC COVER