12 14 521 Replacing the pulse sensor on the crankshaft (B38, B48, B46)
WARNING: This page is about a different variant/trim than selected.
Attention!
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) !
Necessary preliminary work:
- Remove FAN COWL .
Removal:
Unlock connector (1) from pulse sensor and detach.
Release screw (2).
Remove pulse generator (3).
Installation:
Install pulse sensor (3).
Tighten screw (2).
Tightening torque 13 62 2AZ .
Attach connector (1) on pulse sensor.
Connector (1) must engage audibly.
Required follow-up work:
- Install FAN COWL .