11 23 010 Removing and installing/replacing vibration damper (B48AO0)

Special tools required: 

• 11 8 180
• 2 288 159

Necessary preliminary work: 

• Release DRIVE BELT FOR ALTERNATOR 

Removal: 

Undo the transmission bolts (1).

Remove protective cap (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Prepare special tool 11 8 180/1 with special tool 11 8 180/3, 11 8 180/4 and 2 288 159.

Secure special tool 11 8 180 with the transmission bolts.

Slide special tool 2 288 159 into the transmission housing and fasten the flywheel.

Tighten down all screws.

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken all screws on the vibration damper (1).

Feed out and remove vibration damper (1) from drive belt.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

• Replace FRONT CRANKSHAFT SEAL 

Installation: 

Coat the sealing surface on the vibration damper with clean engine oil.

Position vibration damper (1).

Route drive belt (2) properly over the vibration damper.

Tighten down all screws.

Tightening torque 11 23 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Undo the Torx screws.

Remove special tool 11 8 180 with 2 288 159.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down Torx screws (1).

Tightening torque 24 00 1AZ .

Mount protective cap (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Tension DRIVE BELT FOR ALTERNATOR