Install spring suspension strut
NOTE:
TECHNICAL INFORMATION
Keep the connection of the spring strut holder to the spring strut clean and free from oil and grease.
Keep the connection of the spring strut holder to the spring strut clean and free from oil and grease.
- Expand spring strut holder (1) with special tool 2 414 636.
- Protecting the output shaft from damage with a towel is mandatory (2) .
- Align spring strut holder (1) using the gap on the reference mark on the spring strut.
- Insert and position spring strut holder (1)
on spring strut.
The spring strut holder (1) must be pushed up to the limit position on the spring strut!
- Remove the special tool 2 414 636 .
- Remove towel (2) .
- Replace the screw (2)
.
Parts: Screw
- Screw the screw (2) into the spring strut holder (1) and tighten it.
TIGHTENING TORQUE SPECIFICATIONS
| Spring strut holder on front spring strut | ||
|---|---|---|
| M10 Replace screw. |
Joining torque | 42 Nm |
| Angle of rotation | 90° | |
NOTE:
TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .
Tighten the screw connection in the NORMAL POSITION .
- Position spring strut holder on wishbone.
- Replace screw (2)
and nut (1)
.
Parts: Bolt and the nut
- Install the bolt (2) .
- Tighten the nut (1) in the NORMAL POSITION .
TIGHTENING TORQUE SPECIFICATIONS
| Bottom wishbone on spring strut holder | ||
|---|---|---|
| M14 Replace screw and nut. Tighten screw connection in normal position! |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
Fasten the stabilizer anti-roll bar link to the spring strut holder
- Position the stabilizer anti-roll bar link (2) to the spring strut holder.
- Replace nut (1)
.
Parts: Nut
- Tighten nut (1) .
NOTE:
Counter-hold at the Torx socket.
TIGHTENING TORQUE SPECIFICATIONS
| Anti-roll bar link on anti-roll bar/spring strut (air suspension) | ||
|---|---|---|
| M12 Replace nuts. |
tightening torque | 100 Nm |
Follow-up work
- Refer to SECURING THE TOP WISHBONE ON THE SWIVEL BEARING .
- Refer to SECURING THE FRONT AIR SUSPENSION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT THE REAR LEFT OR RIGHT .
- Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to GREASE THE WHEEL HUB .
- Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .