63 11 731 Replace LED module for left daytime driving lights (late version)

Necessary preliminary tasks:

Release screws (1).

Tightening torque 63 11 6AZ .

Remove cover (2).

Installation note:

Check protective cap (2) is correctly seated.

Fig 1: Identifying Protective Cap, Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage due to moisture penetration!

Installation note:

Bolt shackles must not be damaged or missing.

The seal (1) must not be damaged or missing.

Replace protective cap (2) if necessary.

Fig 2: Locating Protective Cap Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect the connector (1).

Unfasten screws (2).

Tightening torque 63 11 4AZ .

Feed out LED module (3).

Fig 3: Identifying LED Module, Connector, Screws

Courtesy of BMW OF NORTH AMERICA, INC.