41 12 654 Stripping Operations - Replacing Right Luggage Compartment Floor (Right Side Wall And Tail Panel Removed)

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.

Remove cover (1) and release nut (2) below it.

Tightening torque: 61 21 4AZ .

Courtesy of BROWN, BOVERI & CO., LTD.

Turn the lock (2) counterclockwise and remove.

Push the positive battery wire connector (1) through the luggage compartment floor to the outside.

Courtesy of BROWN, BOVERI & CO., LTD.

Release plug connection (1) on power distribution box.

Release positive wire (2) on mounting (3) and press grommet (4) through to the outside with positive battery cable.

Courtesy of BROWN, BOVERI & CO., LTD.

Unlock plug connections (1) and disconnect.

Release nut (2) and remove POSITIVE BATTERY CABLE DISTRIBUTOR (3).

Tightening torque: 61 21 2AZ .

Release wiring harness (4) from retaining pin.

Partially release the insulating mat (5) and set aside.

Courtesy of BROWN, BOVERI & CO., LTD.