51 24 325 Removing and installing/replacing left tension spring for tailgate

Necessary preliminary tasks: 

• Remove COVER FROM TAIL PANEL 

Lever out cover (1) and release screw underneath.

Tightening torque: 51 47 1AZ .

Remove lashing eye (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove storage tray (1) in upward direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Release expanding rivets (1).

Feed out luggage compartment wheel arch panel (2) in rear area but do not completely remove.

If necessary, unlock plug connection for charging socket and disconnect.

Installation note: 

Luggage compartment wheel arch panel (2) must fit correctly under tailgate rubber seal (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Note down position of tension spring (1) at rear holder (2).

Detach tension spring (1) from rear holder (2).

Feed out tension spring (1) from hinge (3).

Installation note: 

Reattach tension spring (1) to rear holder (2) again in the same position.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Positions (1 to 3) influence the closing force of the tension spring.

1. Soft (factory setting without rear spoiler)
2. Medium
3. Hard (factory setting with rear spoiler)

If the closing force needs to be changed: Adhere to NOTES ON CLOSING FORCE SETTING .

Courtesy of BMW OF NORTH AMERICA, INC.