Installing the alternator
- Slightly push back the threaded support sleeve (2) in the direction of the arrow to facilitate the installation of the alternator.
- Screw the screw (1) into the threaded support sleeve (2).
- Press back the threaded support sleeve (2) using the bolt (1).
- Once again unscrew the screw (1) from the threaded support sleeve (2).
- Insert and install the alternator (2).
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Alternator on component carrier | ||
| M10x75 | tightening torque | 38 Nm |
| M10x125 | tightening torque | 38 Nm |
| M10x90 | tightening torque | 38 Nm |
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATION
| Positive battery cable to the alternator | ||
| M8 | Tightening torque | 19 Nm |
- Connect and lock the connector (2).
The connector (2) must engage audibly.
Follow-up works
- Refer to PREPARING THE THROTTLE BODY .
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to CONNECTING THE CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING CLEAN AIR PIPE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to WHEN REPLACING THE ALTERNATOR/ALTERNATOR REGULATOR: RESET GENERATOR STATISTICAL DATA .