Removing the DME control unit
Precondition
- Ignition is switched off.
WARNING:
Working on 12 V electrical system.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
Preliminary work
- Refer to REMOVING THE LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to DISCONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to UNINSTALLING THE COVER FOR THE DME CONTROL UNIT .
- Refer to DISCONNECTING THE CONNECTOR FROM THE DME CONTROL UNIT AND FROM THE POWER DISTRIBUTION BOX (PDM) .
NOTE:
TECHNICAL INFORMATION
Follow instructions for removing and installing control units.
For additional information see: 12 00... Notes on removal and installation of control units
Follow instructions for removing and installing control units.
For additional information see: 12 00... Notes on removal and installation of control units
NOTE:
TECHNICAL INFORMATION
In a warranty case, you must always provide a fault memory printout with the defective part, even if the fault memory does not contain an entry.
In a warranty case, you must always provide a fault memory printout with the defective part, even if the fault memory does not contain an entry.
- Unlock clamps (1) .
- Remove the DME control unit (2) towards the top.