Replacing the cushion for the front seat
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Preliminary work
- Refer to REMOVING THE FRONT STRAP FITTING .
- Refer to REMOVING FRONT SEAT .
- Refer to REMOVING INNER COVER FROM THE FRONT SEAT .
- Refer to REMOVING THE OUTER COVER ON THE ELECTRICAL FRONT SEAT .
- Refer to REMOVING OPERATING UNIT FOR SEAT ADJUSTMENT .
- Refer to REMOVING THE SUPPORT FOR THE SWITCH COMBINATION FOR ADJUSTING THE SEAT .
- Refer to REMOVING THE THIGH SUPPORT ON THE FRONT SEAT .
- Refer to REMOVING THE SEAT COVER WITH THE CUSHION FOR THE FRONT SEAT .
- Refer to REMOVING THE FRONT HEAD RESTRAINT .
- Refer to REMOVING GUIDE SLEEVE FOR FRONT HEAD RESTRAINT .
- Refer to REMOVING REAR PANEL ON THE FRONT SEAT BACKREST .
- Refer to REMOVING THE SIDE AIRBAG FROM THE FRONT SEAT .
- Refer to REMOVING THE BACKREST COVER WITH THE UPHOLSTERY FOR THE FRONT SEAT .
- Refer to REMOVING THE BACKREST COVER FROM FRONT SEAT-BACKREST .
- Refer to REMOVING SEAT COVER FOR FRONT SEAT (SPORT) .
NOTE:
TECHNICAL INFORMATION
Only US/Canadian version of front passenger seat with seat occupancy mat (CIS):
The seat occupancy mat is bonded to the entire surface of the upholstery and can only be replaced together with the upholstery.
If the seat occupancy mat or cushion is defective, both parts must always be replaced together.
Full operability can only be guaranteed with Original BMW replacement parts.
After installing the seat cover, enable the seat occupancy mat using the BMW programming system via the appropriate service function.
Only US/Canadian version of front passenger seat with seat occupancy mat (CIS):
The seat occupancy mat is bonded to the entire surface of the upholstery and can only be replaced together with the upholstery.
If the seat occupancy mat or cushion is defective, both parts must always be replaced together.
Full operability can only be guaranteed with Original BMW replacement parts.
After installing the seat cover, enable the seat occupancy mat using the BMW programming system via the appropriate service function.
NOTE:
TECHNICAL INFORMATION
The heating mat is glued to the foam pad and cannot be dismantled nondestructively.
When replacing the heating mat, a new one must always be installed with a new foam pad.
The heating mat is glued to the foam pad and cannot be dismantled nondestructively.
When replacing the heating mat, a new one must always be installed with a new foam pad.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.