Install oil level sensor for engine oil
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Prepare the oil-level sensor
- Replace sealing ring (1).
Parts: Sealing ring
- Clean sealing surface on oil sump.
- Insert and install the oil-level sensor (3).
- Tighten nuts (2).TIGHTENING TORQUE SPECIFICATIONS
Oil level sensor to oil sump M6 Joining torque 2 Nm Tightening torque 8 Nm - Connect and lock the connector (1).
The connector (1) must lock audibly.
Follow-up work
- Refer to TIGHTENING THE OIL DRAIN PLUG .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to TOPPING UP THE MOTOR OIL .
- Refer to INSTALLING THE OIL FILLER CAP .
- Refer to CHECKING ENGINE OIL LEVEL .