Installing the rear brake disc

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.

NOTE: RISK OF DAMAGE
Damage to the brake disk .
Unevenness in the contact surface can cause distortion in the brake disc!

Thoroughly clean the contact surface of the wheel hub and remove traces of corrosion if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Position the brake disc (2).
Replace the screw (1).
Parts: Screw
Position and tighten the screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Brake disc to rear wheel hub
M8 Replace screw.	Tightening torque	16 Nm

Position the brake anchor plate (1) in arrow direction.
Replace screws (2).
Parts: Screws
Insert screws (2) and tighten.

TIGHTENING TORQUE SPECIFICATIONS

Brake anchor plate to rear wheel carrier
M12 Replace screw.	Joining torque	30 Nm
	Angle of rotation	90°

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to GREASING BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
Refer to INSTALLING REAR BRAKE PADS .
Refer to INSTALLING REAR BRAKE PAD WEAR SENSOR .
Refer to INSTALLING THE REAR LEFT AND RIGHT WHEELS .
Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .