Removing clean air pipe
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING REAR HOOD SEAL .
- Refer to REMOVING FRONT WINDSHIELD PANEL COVER .
- Refer to REMOVING THE UPPER FIREWALL COVER PANEL .
- Refer to REMOVING THE INTAKE MANIFOLD FOR INTAKE SILENCER HOUSING .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING SUSPENSION CROSS-BRACE .
- Refer to REMOVING THE REAR BULKHEAD .
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
- Unlock and release the engine ventilation lines (1) from the clean air pipe.
- Unlock and release the engine ventilation line (2) from the cylinder head cover.
- Loosen screw (3).
- Unlock and release the clamp (1) (2) on the clean air pipe.
- Slightly lift the clean air pipe (1).
- Unlock and loosen connector (3).
- Loosen clamp (4).
- Feed out clean air pipe and remove (1).