Installing the outer cover on the electrical front seat
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Position cover (1) on the front seat and fasten with the top and bottom latch mechanisms.
- Insert the expanding rivet (2).
- Feed in end fitting (2) and engage.
- Pull the end fitting (2) in direction of arrow until the lock plate (1) engages audibly.
Mounting the front strap fitting correctly
End lining
NOTE: TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period. - Make sure that the retaining tab (1) snaps in correctly behind the pin (2).
- Observe the following animation:
- Slide the cover (1) on the seat belt (2) in a downward direction.
- Perform the concluding check: Pull end fitting forward, upward and backward.
The end fitting can be turned on the bolt if the lock plate is engaged correctly.