LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2017 >> 650i 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 814 (Fuel Supply System - Repair) >> Drawing Off Of Fuel, System Cleaning >> 16 00 510 Conducting leak test on fuel tank and tank venting system

16 00 510 Conducting leak test on fuel tank and tank venting system

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: On vehicles with tank leak diagnosis modules (DMTL), do not work with external pressurization as the tank ventilation system will leak under this condition.
On account of emerging fuel vapors, carry out all work in well ventilated rooms. Or use a suitable extractor system.
Observe country-specific accident prevention and occupational safety regulations.
NOTE: The following procedure is only applicable to vehicles with  the tank leak diagnosis module (DMTL).
For vehicles without  tank leak diagnosis module:
Pressurize FUEL TANK AND TANK VENTING SYSTEM (DIESEL)  or FUEL TANK AND TANK VENTING SYSTEM (PETROL/GASOLINE) .
During the leak test with a leak detector, be sure to follow the operating instructions of the equipment manufacturer.
NOTE: Select "Tank leak diagnosis module (DMTL)" on Diagnosis and Information System (DIS).
  • The leak diagnosis pump pressurizes the fuel tank and tank ventilation system for 30 sec.
  • If pressure is needed for longer than 30 sec., press "Activate" button again after 30 sec.

The leak test can be carried out with a leak detector.

Possible causes may be: