Install high pressure pump
- Feed in and install high pressure pump (2) .
- Replace the bolts (see arrows in illustration).
Parts: screw
- Position the screws (see arrows in illustration) of the high-pressure pump (2) and tighten alternating in 90°-steps .
Compliance with this specification is imperative to make sure that the piston will not break due to twisting.
TIGHTENING TORQUE SPECIFICATIONS
| High pressure pump to cylinder head cover | |
| M6X25 | Replace screws. Tightening torque 12 Nm |
- Connect and lock the connector (1) .
The connector (1) must engage audibly.
Follow-up work:
- Refer to INSTALLING THE HIGH-PRESSURE LINE BETWEEN THE HIGH-PRESSURE RAIL AND THE HIGH-PRESSURE PUMP
- Refer to INSTALLING FUEL DELIVERY LINE
- Refer to INSTALLING THE IGNITION COILS
- Refer to INSTALLING ACOUSTIC COVER AT REAR
- Refer to INSTALLING TENSION STRUT ON SUSPENSION STRUT TOWER .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART
- Refer to INSTALLING ACOUSTIC COVER
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT
- Refer to INSTALLING FAN COWL
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to CONNECTING BATTERY EARTH LEAD
- Install right luggage compartment trim panel. Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES COUPE/CONVERTIBLE) or INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES GRAN COUPE SEDAN) .