Install connecting bracket on the engine block

• Clean sealing surface (1)  .

• Install connecting brackets (2)  and connect to connector (1)  .

• Position connecting brackets on engine block and fasten using screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

• Insert coolant hose on the connecting bracket.

  The marks must be aligned.

• Fasten the coolant hose using the hose clamp (2)  .
• Clip the wiring harness to the connecting bracket using clamp (1)  .

• Lock coolant hose (1)  and insert on connecting bracket.

Follow-up work 

• Refer to INSTALLING HEAT MANAGEMENT MODULE .
• Refer to INSTALLING THE INTAKE PLENUM 
• Refer to INSTALLING THE TANK VENT VALVE .
• Refer to FASTENING CHARGE AIR LINE TO THE THROTTLE BODY .
• Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) .
• Refer to INSTALLING COVER FOR THE DME CONTROL UNIT .
• Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to FILLING THE LOW-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
• Refer to INSTALLING TENSION STRUT ON SUSPENSION STRUT TOWER .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to BLEEDING THE LOW-TEMPERATURE COOLING CIRCUIT .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .