Installing the holder for the Digital Motor Electronics-control unit
- Install the holder (2) for the Digital Motor Electronics-control unit.
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| DME control unit holder on strut tower | |
| 2.5 Nm | |
Follow-up work:
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) .
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT
- Refer to CONNECTING THE BATTERY EARTH LEAD .
- Install right luggage compartment trim panel. Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES COUPE/CONVERTIBLE) or INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES GRAN COUPE SEDAN) .